1
4
3
1 Oil ller cap
2 Dipstick
1 Fuel cooler
2 Radiator and coolers
3 Cooler screen
1 Oil lling plug
2 Oil level gage
3 Leakage oil reservoir for the quick
couplings
Before starting the tractor, please make sure that daily
maintenance checks are done. Daily maintenance check
points are:
1.
Check the engine oil from dip stick
Engine oil stick is situated on the right side of the engine.
Make sure that engine oli level is between the lower and upper mark.
If necessary, add oil through the oil ller cap.
2.
Check coolant level
Make sure that the coolant level in the coolant expansion tank is above the
uid level mark for cold uid. Coolant expansion tank is located under the
engine hood
3.
Visual check: tyres, oil leaks, radiators.
Clean front grill & radiators if needed.
4.
Check oil level in the transmission and hydraulic system
The oil level must be between the minimum and maximum lines of the oil
level gage. Gage is located at the rear of the tractor, next to PTO shaft. If
the leakage oil reservoir for the quick couplings is full, remove the oil and
discard it.
5.
Check Fuel and AdBlue levels
BEFORE DRIVING
THE TRACTOR
9
To Next Page
Loading...