Hiwin S Series Technical Manual

35
C26UE002-2109
RS485 cable (USB to RJ45)
[Note 4] The station number can be set up to 15 (1~F) at most, and station number 0 is Broadcast Mode,
which is only used in specific situations. The station number cannot be repeated in a single serial network.
After setting the station number, you have to power off and restart. The following is an example where the
station number (ID) is set to 15 (F):

Hiwin S Series Specifications

General

Brand	Hiwin
Model	S Series
Category	Robotics
Language	English