Hix HT-600 - Receiving and Setup Guide; Shipping and Returns Procedures; Unpacking and Inspection; Machine Installation Steps

2
RECEIVING & SETUP
SHIPPING OR RETURNS
NOTE: Save all of your shipping/packing materials.
DO NOT RISK COSTLY SHIPPING DAMAGE!
SHIP ONLY IN ORIGINAL BOX.
1. Fasten machine to plywood shipping base with bolts provided.
2. Tie or tape handle securely to base.
3. Place in original box, and put side liner and top liner in place. Fold in
aps and seal the box. (Additional bottom boards, box and liners may
be obtained from your supplier for a nominal cost.)
UNPACKING
Remember to save all packing materials - including box, liner and
board. You may need these for shipping your machine or if a repair is
necessary in the future.
INSPECTION
Inspect your machine for hidden shipping damage. Contact the delivery
company immediately, should you nd damage.
INSTALLATION
1. Remove plywood shipping base bolts (see A and B) and screw on feet
or afx self-adhesive rubber feet provided.
CAUTION: Handle must be tied to base before moving or shipping.
ATTENTION: Immobiliser la poignée avant de trasporter.
2. Carefully cut tape/wrap holding machine closed.
3. Plug the machine into the correct grounded electrical outlet.
WARNING: When using an extension cord, use 12 or 14 ga.-3 conductor.
Maximum length, 25’ (7.762 m).
ATTENTION: Utiliser des ralonges d’au moins 12 à 14 ga - 3 phases;
longueur maximale de 7.7 mètres.