12
TROUBLESHOOTING
NOTE: Specic application instructions are enclosed with transfers.
When you fail to make a successful transfer you can wonder, “Is it
the machine’s fault, or the transfer, wrong settings or what”?
FIRST, THE BASICS:
1. Be sure to set the heat transfer machine to the transfer manufacturer’s
recommended Temperature, Time and Pressure settings. If you don’t
have these specications, contact your transfer supplier for this infor-
mation and any other special application instructions as many of the
new “High Tech” transfers require signicantly different settings and/or
application techniques than those from years past.
2. When you start up your press for the rst time each day, preheat the
pad for a minute. If the press has sat for 3-5 minutes without use, be
sure to “preheat” the pad for 10-15 seconds before loading the shirt or
making the rst transfer.
3. After the shirt is positioned and centered on the preheated pad, “pre-
press” the shirt for 3 seconds to take the wrinkles out and more impor-
tantly, release any excess moisture out of the T-shirt fabric which can
reduce the chance of a successful transfer.
4. With all of the above recommendations, try making a transfer.
5. If successful, great! You are on your way to making some serious
money with your transfer machine!
6. If you have an area that isn’t transferring completely or as you would
like it to, follow these steps to determine the problem.
• Try increasing the pressure on the machine by 10-20%
• Recheck your temperature required and the press readout. You may
want to increase the temperature 10 degrees.
• Try increasing the application time by 2-4 seconds
• If after trying these things there is still a “specic” area (say over in
one corner of the transfer) that isn’t coming out as you would like
it to, then try the same type transfer on a scrap shirt but rotate the
transfer 180 degrees (changing the failure location) If after doing
this the problem area is in the same physical location on the ma-
chine, then you probably have a problem with the pad or possibly a
warped platen if the machine has ever overheated severely. On the
other hand if the transfer failed in the same area on the transfer (af-
ter changing the location of where the problem had previously been
occurring), then you most likely have a problem with the transfer or
it’s application settings (Temperature, Time or Pressure) and you
should contact your transfer supplier to discuss the problem.
Following these basic guidelines can help you be more successful with
each and every transfer!
To Next Page
Loading...
