23
www.hlu.eu
06.2019
6.5 Transport to the place of installation (at the customer‘s site)
Transport must be performed only by qualied personnel in complian-
ce with the local conditions and any warning notes on the packaging
material.
The fan or fan unit is transported on transport pallets to the site.
The fan or transport unit may tip over during transport.
Pay attention to the focus (the focus is centred) and weight (see
technical data).
Secure the fan or the transport unit with appropriated resources
before the transport.
Transport with forklift
J The forklift has to be adjusted according to the weight of the fan or the transport unit.
J Drive with the forks of the forklift between or under the arbors of the transport pallet of the
fan or the transport unit.
J Make sure that the forks of the forklift are completely under the arbor (the forks have to look
out at the opposite).
J Lift the fan or transport unit and transport it.
Weight see cap. 3.
The fan has to be transported with appro-
priated resources at the designated points
and it has to be secured against overturn-
ing.
Attention: The focus must be on the bot-
tom!
The lifting and transporting of the fans can
be done manually depending on the size
and the weight.
Fig. 4| Transport of the fan to the site
Transport of the fan to the site
Operating manual
Centrifugal fans
HF R | RV | MRV
With belt-driven fans, note that the V-belts must be released in case of prolonged storage peri-
ods or standstill ( > 4 weeks ), in order to prevent damage of bearings and V-belts.
To Next Page
Loading...
General