© 2018 HM Electronics, Inc. The HME logo and product names are trademarks or registered trademarks of HM Electronics, Inc. All rights reserved. EOS | HD is covered by U.S. Patents 9639906, 7920539 & 9484041.
HME# 402G040 Rev: A
For help, call 800.848.4468 (options 1-2-3) or email support@hme.com
HME Training Portal
Find videos, supporting documents and other training guides.
EOS
|
HD
®
Headset Quick Start Guide
How to Register an EOS
|
HD Headset or Belt-Pac
During the installation of your EOS | HD system, each headset or
belt-pac was registered to the base station. If you replace or add
a new headset or belt-pac, it must be registered before it
can be used.
To begin registration:
• Press any triangular button on the base station to
illuminate home screen
• Press Menu button on lower left of screen
• On MAIN MENU screen, press Register headsets button
Please note that a maximum of 15 headsets or belt-pacs can
be registered to the base station. If the maximum number is
reached, the base station HEADSET REGISTRATION screen will
indicate that 0 or more headsets can be registered. To register
additional headsets, the inactive ones need to be cleared. To clear
inactive headsets, refer to instructions at the bottom of this page.
Next, put the headset or belt-pac into registration mode:
• Power off headset or belt-pac by holding power button for three seconds
• Press and hold power button for five seconds
• Above headset control panel, you will see a flashing red and green light and hear a voice in headset state “registration”
• On belt-pac, two red lights will flash next to A1 and A2 buttons
Please note that the instructions on the base station TO REGISTER HEADSETS screen, are an alternative way to put the headset or belt-pac into registration mode.
Complete registration on base station:
• On HEADSET REGISTRATION screen, press Register headsets button
• If you are registering only one headset or belt-pac on TO REGISTER HEADSETS screen, press Register single button
• If you are registering more than one headset or belt-pac, press Register multi button
• Solid green light will appear on headset or belt-pac once registered and ID number will appear on base station screen
How to Clear Inactive EOS
|
HD Headsets or Belt-Pacs
• On base station, press any triangular button to illuminate home screen
• Press Menu button on lower left of screen
• On MAIN MENU screen, press Register headsets button
• On HEADSET REGISTRATION screen, press Clear inactive button
• Turn on all headsets you do not want to inactivate
• Press Clear inactive button
• Press Back button below base station screen to return to HEADSET REGISTRATION screen
www.hme.com/training
Base Station
All-in-One (AIO) Headset Headset & Belt-Pac
EOS | HD — Look for the unique earpiece design.
To Next Page
General
