HME HS6000 User Manual

HS6000
HM ELECTRONICS, INC. 14110 Stowe Drive, Poway, CA 92064 USA • Phone: 1-800-848-4468 Fax: (858) 552-0172
HME# 400G574
Rev D 11/4/10
Wireless Headset
OPERATING INSTRUCTIONS
SETUP
Power
button
Power On/Off
To turn the power on
Press and release the power button on the inside of the
headset housing, shown in Figure 1. A voice message in the
earpiece will say “Headset #, Battery Full/Half/Low” and the
power light on the opposite side of the earpiece will go on.
See Figure 2.
Figure 1. Headset power button
To turn the power off
Press and hold the power button for approximately 3 seconds.
A voice message in the earpiece will say “Headset off,” and the
power light on the opposite side of the earpiece will go off.
Power
light
Configure Headset
Start with power OFF and press any of the following button combinations
while turning the power ON. Immediately release all buttons after
pressing the power button. Each of these settings has an associated
voice prompt. Listen to the voice prompt to confirm the setting.
• Hands Free (HF) on/off – Press and hold B and the UP arrow S
while you press the power button to turn the headset on in the HF
mode. With the power off, press and hold B and the DOWN arrow T
while you press the power button to turn off the HF mode.
Figure 2. Headset buttons
and power light
• Auto HF (AHF) – Press and hold A1 or A2 and the UP arrow S while you press the power button to turn
the headset on in the Auto HF mode. When you turn the headset off, the AHF mode will not be saved.
If you have a Wireless IQ
TM
system; open the base station and set the base transceiver switch K1-3
to the ON position (See Figures 3 & 4).
If you have an ionIQ
TM
system; in the USA call HME Customer Support at 1-800-848-4468,
outside the USA, call your local HME representative for help.
• Language selection – To change between English and another language, press and hold A1 and the
DOWN arrow T while you press the power button to turn the headset on. Doing this again changes
back to the first language.
• Play status – Press A2 and the DOWN arrow T while you press the power button to turn the
headset on. An example of the status you will hear is: “Headset #, Battery Full/Half/Low,
English/Espanol, Hands-free on/off, firmware version #.”

HME HS6000 Specifications

General

Brand	HME
Model	HS6000
Category	Headsets
Language	English

Summary

SETUP

Power On/Off

Steps to turn the headset on and off using the power button.

Configure Headset Modes

Options to set headset modes like HF, AHF, language, and play status.

Headset Registration

Wireless IQ Registration

Steps to register a headset with a Wireless IQ base station.

ionIQ Registration

Steps to register a headset with an ionIQ base station.

Wearing the Headset

Talking to Customers

Talking to Other Crewmembers

Battery Management

Routine Operation

Single-Lane Operation

Operating the headset in a single-lane configuration for one speaker post.

Dual-Lane Operation

Operating the headset in a dual-lane configuration for two speaker posts.

Regulatory Compliance

WEEE Disposal Instructions