D340
MIXER
F-8426 – D340 Mixer Page 3 of 4
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
SPECIFICATIONS
MOTOR:
1
1
⁄2 H.P., Hobart designed, permanently lubricated
ball bearings, totally enclosed, fan-cooled.
Single-phase is capacitor-start, capacitor-run type.
Three-phase is squirrel cage, induction-run type.
ELECTRICAL:
120/60/1, 208/60/1, 240/60/1, 208/60/3, 240/60/3,
and 480/60/3 – U L Listed. Also available in 380/50/3
and 415/50/3 – not submitted for U L Listing.
CONTROLS:
Magnetic contactor with bimetallic thermal overload
protection internally mounted. “Start-Stop” push-
buttons protected by rubber caps. A 15-minute
electric timer is standard.
TRANSMISSION:
Gear-driven. Gears are constant mesh heat-treated
alloy steel. Anti-friction ball or roller bearings.
A hardened steel worm and alloy bronze worm gear
transmit power from motor to transmission. Grease
lubricated.
SPEEDS:
Three positive speeds - Low, Intermediate, and High.
Agitator Attachment
(RPM) (RPM)
Low 96 56
Intermediate 179 104
High 319 185
BOWL GUARD:
Heavy-duty stainless steel wire front and solid
stainless steel rear portion. Front portion of guard
rotates easily to add ingredients and install or
remove agitator. It detaches in seconds for cleaning
in dishwasher or sink. Rear portion of guard can be
quickly cleaned in position. Guard must be in closed
position before mixer will operate. The bowl support
lock prevents the bowl from being lowered while
mixer is running. Bowl support interlock provides
further protection.
BOWL LIFT:
Hand crank operated, self-locking in any position.
FINISH:
Metallic Gray Hybrid Powder Coat finish. Top
Charcoal Gray, Polyurethane Enamel.
STANDARD EQUIPMENT:
Consists of the mixer unit with one (1) 40-quart
stainless steel bowl, one (1) “B” flat beater, one (1)
“D” wire whip, one (1) stainless steel “ED” dough
hook and stainless steel bowl guard.
ATTACHMENT HUB:
Equipped with front-mounted Hobart standard #12
taper attachment hub, and any #12 size attachments
may be used.
NOTE: Use of attachment hub during mixing opera-
tion may result in a negative impact on performance
and longevity of mixer.
ATTACHMENTS AND ACCESSORIES:
The following are available at extra cost:
Hobart Bowl
Scraper
Hobart Ingredient
Chute
Bowl Truck
Bowl Scraper
20 Quart Accessories
Ingredient Chute
9" Vegetable Slicer
Meat Chopper Attachment
Stainless Steel Bowl
“B” Flat Beater
“C” Wing Whip
“D” Wire Whip
“ED” Dough Hook
“P” Pastry Knife
“I” Heavy Duty Wire
Whip
LISTED BY: Underwriters Laboratories, Inc. and NSF International.
Certified by the Baking Industry Sanitation Standard Committee.
D340 Mixer Technical Manual Page 5 of 67
To Next Page
Loading...
Need help?
General
