KNOWING YOUR MACHINE
Page 5
KNOWING YOUR MACHINE
1. Control Panel
[1] = Machine ready LED
[2] = Cycle start button
[3] = Cycle selection button
[4] = Machine ON LED
[5] = Line button
[6] = Cycle 1 LED
[7] = Cycle 2 LED
[8] = Cycle 3 LED
[9] = Infinite cycle LED
[10] = Regeneration LED
[11] = Drain cycle LED
[12] = Tank thermometer
[13] = Boiler thermometer
[14] = Indication (green dot) of “coils heating”
2. Installation data
Some of the data required for installing the machine correctly can be found on the data plate on the
unit itself. A copy of the data plate is shown on the cover of this manual for quick reference.
Correct installation is essential for this machine to work properly. Installation must only
be effected by trained, authorised technicians.
3. Training the user
The personnel responsible for the installation must also provide adequate instruction for
users on how the plant operates, and on the safety measures to be adopted. They must also
provide practical demonstrations on how to use the machine and check that all the documentation
supplied with the machine is kept near the machine itself.
It should be remembered that, for maximum lifespan and performance, the machine must be used in
accordance with the operating instructions. These must be kept carefully, and particular care
must be taken with maintenance (routine, periodic and special) and the machine must be sanitised
from time to time using non-corrosive, commercial products.
To Next Page
Loading...
