Hobart FT1000 - Page 9

– 9 –
Removethewasharmsbyliftinguponthearmclearingthetabfromthenotchin
thewasharmsupport.Slideupperarmsforward,swingingfrontofarmdown.Slide
lowerarmsforward,tiltfrontofarmsupwardtoallowwatertodrain.Removearms.
Cleanwasharmsinasink,openingwasharmsliderstoushfoodsoilfromarms.
Removethestrainerbasketsandstrainerpans.Alsoremovethedualrinsestrainer.
Empty strainers in trash receptacle or food waste disposer. DO NOT STRIKE
STRAINERPANSORSTRAINERBASKETSONSOLIDOBJECTTODISLODGE
DEBRIS. Scrub strainer pans and strainer baskets in a sink.
Removedualrinseandnalrinsearmsandcleandebrisfromnozzlesandarms.
Neverusesteelwooltocleanwarewashersurfaces.Useonlyproductsformulated
tobesafeonstainlesssteel.
Flushtankswithawaterhose,removinganyaccumulationoffoodsoil.
Reinstallallarmsintheirproperlocationandorientation.Ensurethatupperarm
nozzlespointdownward,andlowerarmnozzlespointupward.
Toinstallwasharms,slidemanifoldsonthesupportstowardtherearofthemachine
and ensure the tabs on the sides of the arms drop into the notches in the supports.
Replacethestrainerpansandstrainerbaskets.Reinstallthecurtainsaccordingto
thecurtainchartshownonpages14-15ofthismanual.Leavethemachinedoors
opentoallowtheinteriortoairoutanddry.
Cleanmachineexteriorlikeanyotherstainlesssteelappliance.Usedampcloth
andmildsoapywater.
Spraythechannelswherethesensorsarelocatedattheloadendofthemachine
(Fig.12).Donotattempttocleanthesewithmetallicobjectsasdamagetosensors
can occur.
Fig. 12