BA-21426-002-EN 06.08.2010 13
EN
SELECT PROGRAM:
– The machine runs automatically using the Standard cycle program.
If needed, it is possible to select a different program.
– To show the present program, push the Program button
➁
before
starting the wash cycle. To change the program, push the Program
button again. The theoretical runtime is then shown in the lower
display.
P01 = Short cycle
P02 = Standard cycle
P03 = Long cycle
FX: with exchange of tank water
GX: with increased rinse volume
P04 = GXHK only: Cold Water Rinse (display “COL“)
H = Hygiene cycle (see section 5.4.)
An endless cycle will be indicated by moving light points in the displays.
To stop the wash cycle, push ON/OFF button
➀
(After 20 minutes the
machine will stop automatically.). After a short break, rinse starts auto-
matically.
The Special cycle “Cold Water Rinse” (GXHK model) is indicated on the
display by the letters “COL”.
The machine continues with the chosen cycle until it is switched off or
another program is chosen.
4. OPERATION
To Next Page
Loading...
