Typical Installation for Optional Spool Gun 3035-20 to Handler
®
140
Item Hobart Package Part # Miller Package Part #
Contact Tips
.023/.025 in. (0.6 mm) #770174 (5 per package) #087 299 (10 per package)
.030 in. (0.8 mm) #770177 (5 per package) #000 067 (10 per package)
.035 in. (0.9 mm) #770180 (5 per package) #000 068 (10 per package)
MIG Nozzle (Standard) #770404 #169 715
Gasless Flux-cored Nozzle #770487 #226 190
Tip Adapter #770402 #169 716
Liners
.023/.025 in. (0.6 mm) #196139 #194 010
.030/.035 in. (0.8/0.9 mm) #196139 #194 011
.035/.045 in. (0.9/1.2 mm) #196140 #194 012
Power Source Drive Rolls
Dual-groove, V-smooth — #237338 —
For .023/.025 in. (0.6 mm) and
.030 – .035 in. (0.8 – 0.9 mm) wire
Dual-groove, V-knurled — #202926 —
For .030 – .035 in. (0.8 – 0.9 mm)
and .045 (1.2 mm) flux-cored wire
Dual-groove, V-knurled and V-smooth — #246565 —
For .030 – .035 in. (0.8 – 0.9 mm)
flux-cored and solid wire
Consumables
For Handler
®
140, combine Spool Gun 3035-20 with SGA 100 to weld 14 gauge to 1/8 in. aluminum. To weld aluminum with comparable, competitive
power sources, the spool gun may also be used with the SGA unit.
Note: Refer to SGA Owner’s Manual for complete installation instructions.
To Previous Page
Loading...
Need help?
General
