What to do if CB1 opens and the Hobart Handler 125 EZ shuts down?
If CB1 opens and the unit shuts down, you can try the following: Reset the supplementary protector. Also, release the gun trigger and wait until the protection circuit resets, allowing the drive motor to feed wire again.
General| Brand | Hobart |
|---|---|
| Model | Handler 125 EZ |
| Category | Welding System |
| Language | English |
Explains symbols used in the manual to denote hazards.
Details hazards associated with arc welding and safety precautions.
Discusses hazards from welding fumes and gases and necessary precautions.
Details the technical specifications of the welding unit, including output, amperage, and dimensions.
Explains duty cycle, overheating indicators, and precautions to avoid damage.
Guides on choosing a location and connecting the input power for the 115 VAC model.
Step-by-step guide on how to thread welding wire through the gun.
Identifies and explains the functions of the machine's control panel elements.
Provides instructions for replacing drive rolls and wire inlet guides.
A table listing common welding problems and their remedies.
Provides guidance on typical control settings for wire welding based on material thickness.
Addresses causes and remedies for excessive spatter and porosity during welding.
Explains how to fix excessive penetration issues in welds.
Provides solutions for welds that lack sufficient penetration and fusion.
Addresses issues related to burn-through during welding and how to prevent it.
A comprehensive troubleshooting guide for common welding equipment problems.
To Next Page