To Next PageTo Next Page
Need help?Do you have a question about the Hobart KitchenAid KDC-18 and is the answer not in the manual?
General| Type | Built-In |
|---|---|
| Energy Star Certified | Yes |
| Wash Cycles | 6 |
| Color | Stainless Steel |
| Drying System | Heated Dry |
| Water Consumption | 3.5 gallons per cycle |
Emphasizes disconnecting power before servicing and not reusing gaskets.
Step-by-step guide to remove the lower front panel for access to internal components.
Instructions for removing the outer door panel to access internal door components.
Steps to remove the control panel for access to switches and timers.
Details how to test, service, and replace the drain valve.
Procedures for testing and replacing the fill valve.
Information on the overfill control switch and its adjustment (not recommended).
Details servicing the thermostat and thermal protector for KDS models.
Steps for replacing the dryer thermal protector.
Procedures for replacing the dryer heating element and blower unit.
Detailed steps for replacing pump components and motor shaft seals.
Instructions for proper installation of drain pump impeller and shaft seal, including shim usage.
Steps for assembling and spacing the wash pump impeller correctly.
Step-by-step guide for removing and reinstalling the motor and pump unit.
Detailed instructions for disconnecting the wiring harness for KDP and KDS models.
Instructions for disconnecting the wiring harness for KDI and KDC models.
How to service and adjust the door latch mechanism for proper operation.
Electrical schematic illustrating the KDC-18 series dishwasher wiring.
Electrical schematic illustrating the KDI-18 series dishwasher wiring.
Electrical schematic illustrating the KDP-18 series dishwasher wiring.
Electrical schematic illustrating the KDS-18 series dishwasher wiring.
