– 7 –
ELECTRICAL CONNECTIONS
Electrical and grounding connections must comply with the applicable portion
of the National Electrical Code and/or other local electrical codes.
Disconnect the electrical power to the mixer and follow lockout / tagout
procedures.
A hole for 3/4"-trade-size conduit is located at the top of the pedestal. Make electrical connections per the
wiring diagram located on the inside of the top cover.
Single-Phase Mixer:
• Connect eld supply lead wires to L1 and L2.
• Connect ground wire to ground lug on the mixer.
• Cut o stripped portion of L3 on Legacy+
®
Mixer and wrap securely with electrical tape to insulate
the exposed conductor.
Three-Phase Mixer:
• Connect eld supply lead wires to L1, L2, and L3.
• Connect ground wire to ground lug on the mixer.
To Next Page
Loading...
