8 08.10.2010 BA-21870-001-GB
GB
Generally, all models leaving the factory are equipped with integrated
dispensers.
When retrofitting with other dispensers, please follow the instructions
below.
Attention:
All below-mentioned steps must be carried out by service tech-
nicians qualified by Hobart.
Before removing the housing, make sure the machine is volt-
age-free. Make sure to observe all precautionary measures
required when working near live components.
! Tank must be drained.
! Switch off main switch or unplug.
! Remove front panel.
To connect a liquid detergent dispenser:
! For rinse aid dosage, a dosage nipple is available on the top of the
booster.
! Connect a hose (PVC / Ø 6 mm outside × Ø 4 mm inside) between
outlet of the detergent pump and the detergent inlet (A) of the wash
tank. Tighten with hose clamp.
! Install detergent pump or mount externally.
2. DISPENSER CONNECTION
To Next Page
Loading...
