EasyManua.ls Logo

HobbyKing Katana EPP-30E User Manual

HobbyKing Katana EPP-30E
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Instructions Manual
Many thanks to choosing our 3D
stu
nt plane. We hope you have
many hours of enjoyment flying
it..
Question and Answer IconNeed help?

Do you have a question about the HobbyKing Katana EPP-30E and is the answer not in the manual?

HobbyKing Katana EPP-30E Specifications

General IconGeneral
BrandHobbyKing
ModelKatana EPP-30E
CategoryToy
LanguageEnglish

Summary

Aircraft Specifications and Recommendations

Key Aircraft Specifications

Details on wingspan, fuselage length, wing area, takeoff weight, and center of gravity.

Recommended Control Throws

Suggested control surface throws for 3D and normal flying modes for ailerons, elevator, and rudder.

Recommended Power Configuration

List of recommended motor, ESC, battery, propeller, and servos for the aircraft.

Flight and Storage Precautions

Safe Flying Conditions

Essential advice on avoiding hazardous flying conditions like bad weather, interference, and obstacles.

Model Storage Guidelines

Instructions for safe storage, including battery removal and hanging the model.

Aircraft Assembly Steps

Initial Component Installation

Steps for installing the motor mount, elevator servo, and undercarriage.

Hinge and Control Horn Setup

Instructions for preparing ailerons and elevator for hinges and installing control horns.

Wing and Tailplane Assembly

Attaching Wings and Servos

Procedure for inserting wings, routing servo leads, and securing the wing peg.

Tailplane and Elevator Mounting

Steps for sliding the tailplane through the fuselage and fitting elevator hinges.

Final Assembly and Checks

Tailplane Alignment

Ensuring the tailplane is centered, square to the fuselage, and parallel to the wing.

Rudder and Control Horn Installation

Installing the rudder control horn and fitting the rudder with hinges.

Power System and Landing Gear Installation

Motor and ESC Installation

Installing the motor speed controller and preparing the motor cowling.

Propeller and Cowling Fitment

Fitting the propeller, spinner, and cowling, and installing the wheels.

Control System Integration

Pushrod Installation

Installing the aileron and elevator pushrods for control surface connection.

Final Connections and Checks

Connecting ESC and servos to receiver and verifying control directions.

Landing Gear Attachment

Installing the carbon landing gear and wheel covers to the fuselage.

Related product manuals