Install the aileron servo mount
and servo as shown in the picture
above.
Fit and glue in place the elevator hinges
(Note: It is recommended to keep a 1mm gap
between the elevator and tailplane so that the
elevator can move freely without binding.)
Insert the wings either side of
the fuselage and feed the aileron
s
servo leads through into the
receiver compartment.
As shown in the picture, tension
the wing hooks with a rubber band
an
d wrap around about 3 times.
Please ensure the wing peg is
lo
cated properly for safety.
As shown above slide the
elevator and then the tailplane
through the fuselage.
To Next Page
Loading...
