Also ensure that the tailplane
is par
allel with the wing and
vertically inline with the fuselage.
Install the rudder control horn
as
shown with a medium CA adhesive
As shown in the picture install
the elevator control horn, glue into
position with medium CA glue.
As shown above ensure the
tailplane is perfectly centered and
square to the wing and fuselage. When
measured as
above both measurements
should be the same.
Glue the tailplane into place
using medium CA or appropriate
foam glue.
As
shown in the picture, install the
rudder and glue the hinges in position
with CA adhesive. (Note: Please leave a
gap of about 1mm to allow the rudder to
move without binding. )
To Next Page
Loading...
