Need help?Do you have a question about the Hofmann Megaplan MS400-2 and is the answer not in the manual?
General| Balancing Accuracy | 1 g |
|---|---|
| Rim Diameter | 10"-24" |
| Rim Width | 1.5" - 20" |
| Max Wheel Weight | 65 kg |
| Power Supply | 230V 1ph 50/60Hz |
Procedure for modifying the wheel balancer for different power supply voltages.
Steps to initialise the logic board of the wheel balancer.
Guide to running self-diagnostics on the wheel balancer.
Instructions for resetting the spindle unbalance on the wheel balancer.
Steps to activate the automatic gauges on the wheel balancer.
Instructions for adjusting the distance sensor of the wheel balancer.
Procedure for adjusting the diameter sensor on the wheel balancer.
Steps for assembling the threaded terminal onto the wheel balancer.
Guide on how to assemble the protective guard onto the wheel balancer.
Detailed steps for removing the weight tray from the wheel balancer.
Procedure to replace the magnetic phase generator for the M400-2 model.
Procedure to replace the magnetic phase generator for M400P-2 models.
Instructions for replacing the gauge unit and cylinder unit.
Steps for replacing the piezo sensors on the wheel balancer.
Procedure for replacing the main power board of the wheel balancer.
Comprehensive guide for calibrating the wheel balancing machine.
Steps to perform a test on the encoder count of the wheel balancer.
Procedure for verifying the wheel balancer's calibration.
Instructions for performing a machine oscillation test.
Guide for calibrating the distance gauge on the wheel balancer.
Procedure for calibrating the diameter gauge of the wheel balancer.
Steps for calibrating the width sonar sensor on the wheel balancer.
Procedure for safely removing the mechanical brake assembly.
Steps to perform a functional check on the distance gauge.
Procedure for checking the belt tension on the wheel balancer.
Instructions for adjusting the belt tension for optimal performance.
Procedure for testing the insulation of the piezo sensors.
Steps for replacing the air springs on the wheel balancer.
Instructions for refastening the VDD unit after maintenance.
Procedure for replacing the VDD belt on the wheel balancer.
Electrical schematic for M400-2 and M400P-2 models.
Electrical schematic for the M400P-2(D) model.
To Next Page