Seite 85 von 99
C28 Display of the last 10 kernel error messages
Displayed on selection:
A 6 hex-digit error number is displayed across both displays. At two second intervals this number is
switched with a number from 1 – 10 (1 being the most recent) indicating which error message is
currently displayed.
Step 1 options:
Pressing the PLUS and MINUS keys cycles through the list of error codes.
Pressing the PLUS and MINUS keys together at any stage will act like an Escape key and exit the code.
Pressing the RETURN key will also exit the code.
C43 Resetting the Spin Counter C2
Displayed on selection:
"C43" in left display, "0" or "1" in right display. 0 is normal, 1 is counter reset.
Step 1 options:
The PLUS or MINUS keys will toggle the status of the code between 0 and 1. Pressing RETURN with 0
displayed exits the code without resetting the counters. If 1 is displayed and return is held down for 10
seconds the code is exited and the counters are reset.
Pressing the PLUS and MINUS keys together at any stage will act like an Escape key and exit the code
without changing anything.
C47 Configuring the non-volatile memory (C46 pre-version 3.50)
Displayed on selection:
"b9000", "B9450" or "b9460" in displays.
Step 1 options:
The PLUS or MINUS keys will toggle the selected machine model. Pressing RETURN will program the flash
for the appropriate machine. The machine will then reset.
Pressing the PLUS and MINUS keys together at any stage will act like an Escape key and exit the code
without changing anything.
To Next Page
Loading...
