Need help?Do you have a question about the Hofmann POWER CLAMP features and is the answer not in the manual?
General| Brand | Hofmann |
|---|---|
| Model | POWER CLAMP features |
| Category | Wheel Balancers |
| Language | English |
Explains special features used for easier reading and understanding of illustrations and instructions.
Defines the intended use of the wheel balancer with Power Clamp device and its relation to the basic machine.
Outlines essential safety precautions for operating the machine, including qualifications and general conduct.
Details the operational principles of the power clamping device and its electro-mechanical system for securing wheels.
Explains the use of the pedal for clamping/unclamping the wheel and for actuating the main shaft lock.
Details the step-by-step procedure for clamping and unclamping a wheel using the Power Clamp device.
Describes the function and operation of the main shaft lock for securing the wheel in position.
Procedure for selecting and setting operating modes on balancers equipped with an LC display.
Procedure for selecting and setting operating modes on balancers equipped with a screen display.
How to set the mode that allows wheel removal only when unbalance is zeroed and the screen shows '0-0/OK'.
Lists and explains error codes (E..) displayed on LC screen balancers and how to remedy them.
Lists and explains error codes (E..) displayed on screen display balancers and how to remedy them.
Step-by-step guide for manually unclamping the wheel during power failure or electronic unit malfunction.
Instructions for replacing the standard clamping device with SCA or motorcycle wheel adaptors for wheels without centre bores.
Procedure for readjusting the clamping device by the operator, typically after a conversion or for maintenance.
To Next Page