16
2. Current Mode
Pan Follow Pan & Tilt Follow
All Lock All Follow
Sport Inception
3. Bluetooth: Connected; Disconnected
5. Standby: Gimbal enters standby mode
Low Battery
Current Level Charging
7. Error:
Using gimbal before unlocking roll axis lock pin
or pan axis latch, overload warning, or motor
error due to improper installation/operation.
8. A-B Motion:
Move to the point A from the current
point at a constant speed
Move to the point B from the current
point at a constant speed
10. Firmware Update: Updating
9. Auto Calibration: Calibrating
11. Pair Remote Control (Excluded): Pairing
Pairing Failed
Paired Successfully
6. Pan Axis Latch: Unlock the Latch
4. Battery Level:
To Next Page
Loading...
