20
Firmware Update
You will be prompted in the app Hohem Joy if a new rmware
update is available. Follow the on-screen instructions in the app
to update the rmware.
* Two short beeps, following the calibration failure, indicates
that the gimbal has been in the standby mode. Any button (except
the joystick) can wake up the gimbal. Then, follow the steps
above to re-calibrate.
❸
Press the M button ve
times to enable the auto
calibration and you will
hear a beep sound. Please
do not touch the gimbal
during calibration.
❹
The second beep
indicates that the
calibration is completed,
and the gimbal
will be recentered
automatically.
To Next Page
Loading...
