Periodically treat outside seals with pliable silicone lubricant.
Bedroom Slide-Out
To Extend Slide-out
• Check that you have at least five (5) feet of clearance outside motor home for
slide-out room.
• Locate two locking bar mechanisms on top of slide-out
room inside motor home.
• Move handles to unlocked position, unscrew handles to
release bar mechanisms and remove bars from between
wall and top of slide-out.
• Store bars for reuse before motor home is in motion.
• Press and hold slide-out room switch in the OUT posi-
tion. Switch is located on bedroom wall. Slide-out room
will move slowly to the OUT position and drive motor
will not stop automatically.
• To stop slide-out room before room reaches OUT posi-
tion, release switch.
• To continue room movement push and hold switch in.
To Retract Slide-Out
• Check that there is sufficient clearance inside motor home for slide-out.
• If applicable clean floor.
• Press and hold switch in the IN position. Slide-out will move slowly to the IN posi-
tion and drive motor will not stop automatically.
Admiral
3-22
Appliances & Equipment
Appliances & Equipment
HOLIDAY RAMBLER
2000
!WARNING !
Make sure you have 5 or more feet of clear space on the outside of your
motor home before moving the slide-out in the OUT position. Be sure you have
sufficient clearance of the inside of your motor home before you retract the
slide-out. Do not operate the slide-out when the battery has been removed from
the motor home. Use with the converter only may damage the slide-out’s elec-
trical components. Continuous operation of the slide-out could cause battery
drain and damage to the slide-out motor from over heating.
Never move motor home without having the slide-out retracted.
To Next Page
Loading...
