15
There may be times when it is desirable to run more than one program manually.
The controller allows this to occur using its unique facility of enabling a program,
before running it. For example if I wished to run Program 1 and also Program 2, the
controller will manage stacking of the programs so they do not overlap.
Enable program 1 by pressing the
button. To select the next program press
the
button, the program number will increment to program 2.
Enable program 2 to run by pressing the
button.
NOTE: to disable a program number, press the
button.
Once both programs have been enabled, they can be run by pressing the
button.
The controller will now run all programs that have been enabled starting with the
highest numbered program. So in this case, program 2 would run and when it has
completed its cycle, program 1 would start and run its cycle.
This method can be used to enable any, or all of the available programs on the
controller.
NOTE: When running programs in manual mode the “Budget %” will alter the
running times of each individual station.
MANUAL OPERATIONS
To Next Page
Loading...
