10 | P a g e
Driver Installation
Apple/Mac OS X 10.6.5 and above comes with a driver built in. There is no need to install drivers. Mac OS
does not support DSD Native mode.
Linux has its own built in drivers and does not require driver.
The latest Win10 comes with a driver, but since its own driver does not support ASIO and does not
support DSD, you need to install the driver provided by Holo Audio. The driver installation steps are as follows.
⚫ Connect the device to the power and turn it on, connect the USB input port of the device to the USB
Port of the computer with a USB cable. Select input source on dac to USB. Note: if you do not select
the digital source than the computer will not recognize the device.
⚫ When the device is connected to the computer via USB, the Windows system will display a notification
that the new hardware is found and driver installation failed. Please ignore this notification (see figure
below)
⚫ Locate the driver installation file and double-click to open/run the file.
To Next Page
Loading...
Need help?
General
