9
1.Dual button pushbutton switch mode(Factory default)
2.Dual button interlock switch mode
3.DC246 switch mode
Operate the
Curtain to desired
preferred position
Release button
The Run/Stop by pulling fabric is disabled.
Repeat this operation to enable the Run
/Stop by pulling fabric.
The mode has been
successfully switched
Press 3times
The new close limit has been set successfully
1,In the status that the limit has been set, after the curtain is moved to the position where the curtain needs to be
set, the following operations can be performed.
2,Repeat this operation to cancel the manually set close limit.
4.Single button pushbutton switch mode
Manually Set
The Close Limits
Flashes 5times
Add / Delete A
Preferred Position
Run/Stop By
Pulling Fabric
The factory default Run/Stop by pulling fabric is enabled.
Flashes twice
Flashes 5times
Weak-current
Switch Modes
Flashes twice
Flashes once
Release button
Flashes 5times
Release button
Press twice
The mode has been
successfully switched
Release button
Flashes 5times
The mode has been
successfully switched
Flashes 3times
Release button
Flashes 5times
The mode has been
successfully switched
Flashes 4times
Press 4times
Flashes once Flashes once
Press for 1S Press for 1S Press for 1S
Press for 1S Press for 1S Press for 1S
Press 'STOP' for 2s, the motor automatically moves to its preferred position.
Flashes 5times
Flashes once Flashes once
The preferred position is set.
Repeat this operation to
delete the preferred position.
Press for 5S Press for 1S
Press for 5S
Press for 1S Press for 2S
Flashes twice Flashes twice
Flashes 5times
Press for 5S
Press for 2S
Press for 2S
Press for 5S
Flashes twice
Flashes twice
Press for 5S
Press for 2S
To Next Page
Loading...