SPECIFIC SAFETY RULES FOR TRIMMER USE
■ Make sure all guards, straps, deflectors and handles
are properly and securely attached.
■ Use only the manufacturer's replacement line in the
cutting head. Do not use any other cutting attachment.
■ Never operate unit without the safety guard in place
and in good condition.
■ Maintain a firm grip on both handles while trimming.
Keep bump head below waist level. Never cut with
the bump head located over 76 cm or more above the
ground.
SPECIFICATION
Weight
- Without fuel and string head 4.26 kg
- Without fuel with string head 4.45 kg
Fuel tank volume 425 cm
3
Cutting swath 432 mm
Engine displacement 22 cc
Maximum engine performance
(in accordance with ISO 8893) 0.75 kW
Maximum rotational frequency
of the the spindle 9,000 min-
1
Engine speed (rotational frequency)
at recommended max. spindle
rotational frequency 12,500 min-
1
Engine speed (rotational frequency)
at idle 3,100-4,300 min-
1
Fuel consumption (in accordance
with ISO 8893) at max.
engine performance 0.48 kg/h
Specific fuel consumption
(in accordance with ISO 8893)
at max. engine performance 0.46 kg/h
Vibration level idling
- Front handle 4.8 m/s
2
- Rear handle 4.8 m/s
2
Vibration level racing
- Front handle 13.0 m/s
2
- Rear handle 8.4 m/s
2
Sound pressure level
(in accordance with EN ISO 11806:1997,
ISO 7917:1987) 100 dB (A)
Sound power level (in accordance
with ISO 10884) 112 dB (A)
DESCRIPTION
1. Starter Grip
2. Front Handle
3. Shaft
4. Throttle
5. Safety Guard
6. Trimming Line
7. Bump Head
8. On / Off Switch
9. Throttle Control & Rear Handle
10. Muffler Guard
11. Choke Lever
12. Bolt
13. Bracket
14. Wing Nut
15. Lock Washer
16. Flat Washer
17. Mixture Needle
18. Rear Housing
19. Screws
20. Bent End of Muffler Guard
21. Opening In Rear Housing
22. Torx Wrench
23. Dangerous Cutting Area
24. Best Cutting Area
25. Direction Of Rotation
26. Throttle Interlock
27. Primer Bulb
28. Idle Speed Screw
29. Run Position
30. Half Choke Position
31. Choke Position
32. Bump Knob
33. Slots
34. Eyelets
35. Shaft Of Bump Head
36. Spring
37. First Line
38. Anchor Hole
39. Arrows On Spool
40. Spool
41. Latch
42. Cover
43. Filter
44. Air Filter Cover
45. Fuel Cap
46. Second Line
13
English
To Next Page
Loading...
Need help?
General
