13
LOOSE PARTS LIST
Fig. 6
WARNING:
The use of attachments or accessories not listed might be hazardous and could cause serious personal injury.
Dust Bag
Work Clamp
The following items ar
e included with your Compound Miter Saw:
Hex Key (6 mm)
Operator's Manual
ASSEMBLY
UNPACKING
This product has been shipped completely assembled.
Carefully lift saw from the carton and place it on a level
work surface.
Your saw has been shipped with the saw arm secured in
the
down position. To release the saw arm, push down
on the top of the saw arm, cut the tie-wrap, and pull out
on the lock pin. See Figure 10.
Lift the saw arm by the handle. Hand pressure should
r
emain on the saw arm to prevent sudden rise upon
release of the tie wrap.
Inspect the tool carefully to make sure no breakage or
damage occurr
ed during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
The saw is factory set for accurate cutting. After
a
ssembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
DUST BAG
WORK CLAMP
HEX KEY
To Next Page
Loading...
Need help?
General
