Homelite WF10MSP - Supporting Workpieces During Operation; Supporting Long Workpieces

24
0
OPERATION
Fig. 29
 Grasp the saw handle firmly then squeeze the switch
trigger
. Allow several seconds for the blade to reach
maximum speed.
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the saw blade to stop
r
otating before raising the blade out of workpiece. Wait
until the electric brake stops blade from turning before
removing the workpiece from miter table.
LONG WORKPIECE
WORKPIECE
SUPPOR
TS
SUPPORT LONG WORKPIECES
See Figure 29.
Long workpieces need extra supports. Supports should be
placed along the workpiece so it does not sag. The support
should let the workpiece lay flat on the base of the saw and
work table during the cutting operation. Use the optional
work clamp or a C-clamp to secure the workpiece.