29
OPERATION
5. Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling
the rope.
If necessary, rewind the rope and
pull again. If the engine does not
star
t after several attempts, refer to
TAKING CARE OF
UNEXPECTED PROBLEMS,
p. 58.
6. If the choke was used to start the
engine, return the
knob to the
normal operating position as the
engine wa
rms up.
7. Leave the recoil starter assembly
of
f, but install the engine cover
(p. 42).
8. If it was necessary to remove the
emer
gency stop switch lanyard
from you to perform the emergency
starting procedure, be sure the
lanyard is attached securely to
op
erator before operating the
outboard motor.
9. Have your closest authorized
H
onda marine dealer check your
recoil starter system and correct the
problem, so you can use the recoil
starter.
The recoil starter assembly should
be
reinstalled after the recoil starter
is working again. Install the recoil
starter assembly with the engine
stopped.
Exposed moving parts can cause
injury.
• Do not operate the outboard
motor wi
thout the engine
cover.
• Use extreme care when
installing the engine cover
.
31ZW66320.book 29 ページ ２０１３年１０月４日 金曜日 午後３時４８分
To Next Page
Loading...
