Honda CRF50F 2004-2015 - Fork Service

FORK
FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Install the brake arm by aligning the punch marks
on the
arm and brake cam.
Install a new brake arm pinch bolt and nut as shown
and tighten it to the specified torque .
TORQUE: 5.9 N'm (0.6 kgf -m, 4.3 Ibf.ftl
Apply grease to the anchor pin and brake cam sl id -
ing surfac es.
Install the brake shoes and spring as shown.
Wipe any excess grease of the brake cam and
anchor pin.
INSTALLATION
Install the front wheel (page 12-1 1)
DISASSEMBLY
Remove the front wheel (page 12-8),
Loosen
the brake cable nul and remove the brake
cable
from the fork slider.
Remove the
dust seal from the fork outer tube by
sliding it down.
Remove the stopper ring.
Remove the fork top bolt and washer and pull the
fork slider down to remove the fork assembly.
NUT
12-15