Honda CRF50F 2004-2015 - Page 180

REAR WHEEL/BRAKE/SUSPENSION
Never mSf~J/ the old
beatings, once th e
beBrmgs ha .... been
removed, rhe be ar -
mgmusr be
re plscea wi th new
on es .
13-8
Wheel bearing insta llation
Pack each wheel bearing cavity with grease.
Drive in a new right bearing squarelV with the
sealed side facing up
using the special tools as
shown.
TOOLS:
Oliver
Attachment , 32 II 35 mm
Pilot, 12 mm
07749·0010000
07746·0010100
01746·0040200
Insta ll the distance coliar and drive in a new leh : ~~~~:~ :'~i:~
bearing using the same tools.
Wheel ce nt er adjustment
Place the rim on the wo rk bench.
Place the hub with the l eft side down and begin lac-
ing with new spokes.
Adjust the hub position so that the distance fr om
the hub right end surface to the side of rim is 25 1: 10
mm (1.0 ± 0.04 in) as shown.
TOOL:
Spoke wrench , 4.1 x 4.5 mm 07701·0020100
( Equi valent com-
merciallyav all-
able in U.S.A.)
TORQUE: 2.0 N'm (0.2 kgf -m, 1. 4Ibf.ft)
'&.. .tff 25 ± 1.0 mm
~ (1.0±0.04in)
/
Check the rim runout (page 13-6), :~ •• r=~~ ::;i@~~~~ i~.= ~
Apply grease to a new dust seal lips and install il
into the left wheel hub.
Install the driven sprocket, bolts and nuts and
tighten the nuts to the specified torque.
TORQUE: 32 N·m (3 .3 kgf ·m, 24 Ibf · h)