Honda CRF50F 2004-2015 - Page 65

FUEL SYSTEM
5-10
Hang the float valve onto the float arm lip_
Install the float pin through the float, then install the
floatlfloat pin to the groove on the carburetor body.
Install and tighten the screw.
FLOAT LEVEL INSPECTION
• Set the float level gauge so that it is perpendicu-
FLOAT
FLOAT
lar to the float chamber face and in line wit h the __ ~
main jet.
With the float valve seated and the fl oat arm just
touching the valve, measure the float level with the
special tool as shown.
TOOL:
Carbure tor fl oat level gauge
07401 ·00 10000
FLOAT LEVel : 12 .7 mm 10 .50 in)
The float cannot be adjusted.
If the float level is OUI of specification, Inspect the
float valve and valve seat.
If the float valve and valve seat are normal, replace
the float assembly.
If the floal valve and valve seat are abnormal,
replace them and recheck the float level.
InSlall
a new O-ring into Ihe carburetor groove prop-
erly.
InSlalilhe float chamber.
Install and lighten the float chamber screws.
Install the drain hose.
FLOAT CHAMBER
:# O-RII'G
FLOAT CHAMBER
~
SCREW
FLOAT LE VE L GAUGE
DRAIN HOSE