13-5
HRX217HYA • HRX217HZA TRANSMISSION
8. Insert a screwdriver or rod in the cable bracket hole, pivot
the transmission and install the belt on the driven pulley.
9. Install the clutch cable at the upper handlebar.
10.Connect the end of the clutch cable to the shift lever using
a pin, washer, and cotter pin.
11. Install the rear scroll (P. 1 2- 5
). Be sure that the clutch
cable is positioned against the outside of the mower deck
and does not interfere with the belt or scroll. Tighten the
scroll mounting bolts to the specified torque.
12.Install the shutter (P. 1 2 -1
).
13.Install the wheel covers.
14.Apply grease to the ends of the axle, and install the ratchet
return springs, keys, spacers, and drive gears. Install the
13 mm circlips.
The pinion gears have punch marks on them. Install the left gear so the punch mark faces inside, and install the
right gear so the punch mark faces outside.
15.Install the rear wheels.
16.Secure the cables to the handle pipe using tie straps
(P. 2-26
).
17.Adjust the drive clutch cable (P. 3-15
).
CLUTCH CABLE
WASHER
COTTER PIN
LOCK NUTS
PIN
To Next Page
