Continued
625
uuIf a Tire Goes FlatuTemporarily Repairing a Flat Tire
4. Plug in the compressor to the accessory
power socket.
u Be careful not to pinch the cord in a
door or window.
5. Turn the power system on.
u Keep the power system on while
injecting sealant and air.
2 Carbon Monoxide Gas P. 81
6. Turn the selector knob to REPAIR
*1
,
SEALANT/AIR
*2
, PRODUIT ANTIFUITE/
AIR
*2
.
*1: U.S. models
*2: Canadian models
1Injecting Sealant and Air
Do not operate the temporary tire repair kit
compressor for more than 15 minutes. The
compressor can overheat and become permanently
damaged.
Until the sealant injection is complete, the pressure
shown on the pressure gauge will appear higher than
actual. After the sealant injection is complete the
pressure will drop and then begin to rise again as the
tire is inflated with air. This is normal. To accurately
measure the air pressure using the gauge, turn the air
compressor off only after the sealant injection is
complete.
Running the engine with the vehicle in an
enclosed or even partly enclosed area can
cause a rapid build-up of toxic carbon
monoxide.
Breathing this colorless, odorless gas can
cause unconsciousness and even death.
Only run the engine to power the air
compressor with the vehicle outdoors.
21 INSIGHT-31TXM6200.book 625 ページ ２０２０年２月５日 水曜日 午前１０時０分
To Next Page
Loading...
