About the System (cont'd)
5
User Codes
Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to authorized features and
functions. Users for the system are programmed in a central user setup location that provides the specific questions for authorization
level, partition assignment, and RF zone assignment.
Extended Functionality
Extended functions are advanced functions that can be accessed through a standard alpha keypad or through the console emulation
mode on the 6290W Touchscreen. Refer to the Control Panel User Guide for these features.
LED Operation
The 6290W Touchscreen has three LEDs as follows:
To reset the Touchscreen, press and hold the side Power Button for 3 seconds and then select the reset button on the screen to
start the reset function. The Touchscreen can also be reset by pressing and holding the reset button for approximately15 seconds until
the touchscreen resets automatically.
Safe Mode
The touchscreen contains a Safe Mode of operation. In the rare event that it cannot successfully communicate in its graphic mode with
the control panel, the Safe Mode is a backup mode that ensures that you can communicate with your system. Refer to the Safe Mode
section for further information.
To Next Page
Loading...
Need help?
General
