Security (cont'd)
10
How to Disarm the System
IMPORTANT: If you return to your home or business and the main burglary sounder is on, DO NOT enter the premises, but call the
police from a nearby safe location. If you return to your home or business after an alarm has occurred and the main sounder has shut
itself off, the keypad beeps rapidly upon entering, indicating that an alarm has occurred during your absence. LEAVE IMMEDIATELY
and CONTACT THE POLICE from a nearby safe location.
The system may be disarmed using either of two methods. One method is employed when you enter the premises and the other is
when you have been in the premises with the system armed (i.e., Stay and Night arming modes).
To disarm the system when entering the premises:
The touchscreen automatically displays the Entry Delay Active screen when you enter the premises.
1. Enter your 4-digit user code.
The partition is disarmed and the "Arming" screen is displayed showing the
system as Ready to Arm.
Note: If you have a commercial system and a time window has been defined
for when you may disarm the system, the system does not disarm if you are
outside that time window.
To disarm the system when already in the premises:
1. Select the Disarm button.
2. Enter your 4-digit user code.
To disarm Multi-Partitions do the following:
1. From the Home/Security screen, select the
Security icon.
2. Select the Arm Multi-Partition icon.
3. Select the Disarm icon.
4. Enter your 4-digit user code.
5. Highlight the partition(s) to disarm and
select OK, or select ALL to disarm all
partitions.
All selected partitions should be disarmed, user can enter multi-partition list
to check the status of partitions.
To Next Page
Loading...
Need help?
General
