Security (cont'd)
8
How to Display Faults
The Display Faults function is used when you see a “Not Ready Fault” message and want to determine where the fault is and what type
of fault it is. To display faults do the following:
1. Select the following icons:
Security → More Choices → Show
Zones.
Select the down arrow to view faults.
The drop-down menu displays a listing of fault types. Select the fault type to
view, and a message of current status is displayed on the screen.
As applicable, take corrective action such as closing a window or door to
correct the fault.
2. If the fault cannot be corrected, you may
choose to bypass a zone by selecting the
zone and highlighting it and then selecting
the BYPASS SELECTED icon.
Alarm
Troubles
Faults
Bypass
Low
Battery
All
How to Bypass Zones
The Bypass function is used when you want to arm the system with one or more zones left open. Bypassed zones are unprotected and
do not cause an alarm when violated while the system is armed.
Residential systems do not allow you to bypass fire, carbon monoxide or emergency zones. On commercial fire systems, a
specified user may be allowed to bypass fire, carbon monoxide and system zones if the user was enabled by your system
installer.
Limits apply as to how many zones can be bypassed at one time
. These limits are ten zones on residential systems and five
zones on commercial systems.