19
User Setup
User Setup allows you to Add a User, Delete a User, and Edit a User. You may access User Setup from the System Setup screen.
Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to various features and functions.
The keypad can hold the identity for 10 Users in its memory. The maximum number of Users that can be added is limited to the number
of users that the panel supports.
Users for the system are programmed in a central user setup location that provides the specific questions for authorization levels
assigned to different users. You may want these users to be the same, but there are situations in which you may want a user to have
limited capabilities. These capabilities are defined by the Authority Level assigned each user.
Authority Levels
Authority levels define the system functions a particular user can perform. Depending on the authority assigned to you, there are certain
system functions you may be prohibited from performing. The following information describes the authority levels that can be assigned
through the keypad and provides the equivalent authority level name found in your alarm system manuals. The authority levels that can
be assigned are as follows:
Authority
Level
Functions
Equivalent System Name
Can perform all security functions, add/delete users in assigned partition,
program scheduled events, and change partition master code
Partition Master Level 1 Master
Perform security functions (arm, disarm)
Standard User Level 3 Operator A
Can arm the system in assigned partitions, but cannot disarm the system
unless the system was armed with this code.
Note: Do not assign this level if Quick Arm is enabled in your system.
Guest Level 4 Operator B
Used to restrict access from a partition. N/A N/A
To Next Page
Loading...
Need help?
General
