To Next PageTo Next PageWhat to do if the temperature does not change according to the programmed schedule on my Honeywell Home RLV4305A1014?
If the temperature isn't changing according to the programmed schedule, make sure your Honeywell Home Thermostat is in Automatic mode. Also, double-check the schedule and clock settings. If your thermostat is set to a 12-hour format, confirm that "PM" is displayed for afternoon times.
What to do if LP appears on the screen of my Honeywell Home RLV4305A1014?
If "LP" appears on the screen, even without a power outage, it could indicate that the thermal circuit breaker in the heater has opened. This might happen if the heater is blocked by furniture or a curtain and has overheated, or if the thermal circuit breaker itself is defective or too sensitive.
Why does my Honeywell Home RLV4305A1014 Thermostat display the wrong temperature?
The Honeywell Home Thermostat might display the wrong temperature if it's exposed to an air draft or located near a heat source, such as a light dimmer. Correct these situations to ensure accurate temperature readings.
Why is my Honeywell Home RLV4305A1014 hot?
It is normal for the Honeywell Home Thermostat to feel hot. Ensure that the heater capacity does not exceed the thermostat’s maximum load.
What does LO mean on my Honeywell Home RLV4305A1014 Thermostat?
If "LO" is displayed on your Honeywell Home Thermostat, it means the measured temperature is below the display range. In this state, the heating system is activated.
What does HI mean on my Honeywell Home RLV4305A1014 Thermostat?
If "HI" is displayed on your Honeywell Home Thermostat, it indicates that the measured temperature is above the display range.
Why does my Honeywell Home Thermostat display the wrong time?
The Honeywell Home Thermostat displays the wrong time if it was without power for more than 5 hours.
What to do if E1 or E2 is displayed on my Honeywell Home RLV4305A1014 Thermostat?
If "E1" or "E2" is displayed on your Honeywell Home Thermostat, it indicates reduced thermostat performance due to a sensor error. Please contact technical support for more information.
General| Voltage | 24 VAC |
|---|---|
| Display | Digital |
| Programmable | No |
| Power Method | Hardwired |
| Color | White |
| Backlight | No |
| Battery | No |
| Hold Feature | Yes |
| Filter Change Alert | No |
| Temperature Range | 40°F to 90°F |
| Stages | 1 Heat |
