Package Includes:
• T3 Pro Thermostat
• UWP™ Mounting System
• Decorative Cover Plate –
Small; Size 4.72” H X 5.9” W
(120 mm H X 150 mm W)
• Screws and Anchors
• 2 AA Batteries
• Thermostat Literature
T3 Pro
Thermostat
Installation Instructions
TH3110U2008,
TH3210U2004
Read before installing
Heat On
Menu
Fan Auto
Optional Cover Plate installation
NOTE: If Optional Cover Plate is not required, see “UWP
Mounting System installation” on next page.
Use the Optional Cover Plate when you need to cover
paint gaps from the old thermostat.
1. Before starting, turn the power off at the breaker box
or switch.
2. Mount the Cover Plate to the wall using any of the 6
screw holes. Insert and tighten the mounting screws
supplied with the Cover Plate. Do not overtighten. See
Figure 1. Make sure the Cover Plate is level.
3. Attach the UWP by hanging it on the top hook of the
Cover Plate and then snapping the bottom of the
UWP in place. See Figure 2.
4. If mounting to a wall with no existing wall anchors:
a. Position the Cover Plate on wall. Level and mark
hole positions. See Figure 1.
b. Drill holes at marked positions, and then lightly
tap supplied wall anchors into the wall using a
hammer.
• If your box contains red anchors, drill 7/32” (5.6 mm) holes.
• If your box contains yellow anchors, drill 3/16” (4.8 mm) holes.
• Use 2x supplied screws (#8 11/2” (38 mm) for red anchors and
#6 11/2” (38 mm) for yellow anchors).
2
To Next Page
Need help?
General
