Operation and Programming
8
Cost-saving programme schedules
MondayFriday ON 1 [off 1] ON 2 [off 2] ON 3 [off 3]
Heating 6:30am 8:30am 1:00pm 4:30pm
Hot water 6:30am 8:30am 1:00pm 4:30pm
SaturdaySunday ON 1 [off 1] ON 2 [off 2] ON 3 [off 3]
Heating 6:30am 9:30am 1:00pm 4:30pm
Hot water 6:30am 9:30am 1:00pm 4:30pm
The programmer is preset at the factory to turn off your home heating and hot water when they’re less
likely to be needed. The preset schedules are shown below. To change them, see pages 912. (See also
two alternate schedules on page 25).
To run this schedule (as shown below, or as you’ve modified it), leave the MODE buttons set to Auto.
Y ou can make temporary adjustments at any time (without changing the schedule) by pressing the
EXTRA HOUR or OVERRIDE buttons (see pages 1011).
Default
on/off times
(Schedule A)
TIP: To review your schedule quickly, move the slider to Hot Water or Heating, then press
the OK button repeatedly to see each on/off time period.
RUN
To Next Page
Loading...
Need help?
General
