Honeywell 2911 - Programming and Resetting Your Safe; Set a New Personal Passcode; Test Your New Passcode; Resetting the Safe Passcode

4
PROGRAMMING YOUR SAFE
1. Locate and press the red reset button on the inside of the safe door. (Figure 1)
2. The LED indicator bar, above the keypad, will flash orange, indicating that it is ready for
programming. (Figure 2)
3. Enter your new personal passcode (3-8 digits) followed by the # key.
4. Immediately reenter the new passcode and press the # key to confirm.
• If the passcodes match, the LED indicator bar will turn green; your new passcode is now
set. (Figure 3) Continue to the next section.
• If the passcodes do not match, the LED indicator bar will flash red and revert to the
previous code. (Figure 4) Return to step 1 to begin the programming process again.
1. Begin with the door open and in the locked position. The handle will be in the vertical position
and the door bolt will be sticking out from the side of the door. (Figure 1)
2. Enter the new passcode followed by the # key.
• If the passcode is entered correctly, the indicator bar will turn green. (Figure 2) Proceed to step 3.
• If the passcode is entered incorrectly, the indicator bar will turn red. (Figure 3) Return to
the Programming a New Passcode section to reset your passcode.
3. After entering the correct passcode, lift the handle to the right to retract the bolt and unlock
the door. (Figure 4)
PROGRAMMING A NEW PASSCODE
You can program your safe to open with a personal passcode containing 3 to 8 digits.
TESTING A NEW PASSCODE
After programming your new passcode, you can test it before closing the safe.
Time Out Feature
After entering the passcode, you will have 5 seconds to turn the handle and unlock the door
before the safe will lock again and you will need to reenter the passcode.
RESETTING THE PASSCODE
You can change the passcode for your safe at any time. To reset the passcode, follow the
instructions in the Programming a New Passcode section.
If you have lost or forgotten your passcode, you can use the Override Access Keys to unlock your
safe. Once unlocked, follow the instructions in the Programming a New Passcode section.
Figure 1
Figure 1
Figure 2 Figure 3 Figure 4
Figure 4
Orange = Ready to Program Green = Passcode Set Successfully Red = Passcodes Don't Match
Figure 2 Figure 3
Green = Passcode Set Successfully Red = Passcodes Don't Match