Honeywell 35 Series - Update Firmware Via Web Browser; Figure 12 NVR Upgrading; Figure 13 Reset the NVR

6
Honeywell 35 Series NVR HDD Installation Guide
2. Power off the NVR
3. Plug the USB drive into any one of the NVR’s USB ports.
4. Power on the NVR.
NVR will upgrade automatically, and during the upgrading process, it will reboot. After
upgrading success, it will get into NVR UI interface automatically.
Figure 12 NVR Upgrading
5. If you activated the NVR, after upgrading, please reset the NVR.
6. Go to System > Maintenance. Click Reset then select Restore to factory default to reset the
NVR.
Figure 13 Reset the NVR
Update Firmware via Web Browser
1. Login the NVR via Web browser.
Note:
For the first login, you need to create a new password to activate the NVR