Honeywell 35 Series - Check the Storage Capacity; Figure 18 Restore to Factory Default

9
Honeywell 35 Series NVR HDD Installation Guide
5. Login the NVR. Go to Setting > System > Maintenance.
6. Click on Reset and then select Restore to factory default.
7. Click YES to reset NVR.
Figure 18 Restore to Factory Default
Check the Storage Capacity
Note:
The below description is taking HN35080200 as an example.
1. Login NVR.
2. Go to Setting > Storage > Disk to check if the storage capacity is the same as the HDD
installed in the NVR.