EasyManua.ls Logo

Honeywell 5000 Series User Manual

Honeywell 5000 Series
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INSTRUCTION SHEET
1 EN1R-9175 0908RA-NE
Subject to change without notice. All rights reserved
V7335A “5000” series
ELECTRIC MODULATING PRESSURE REGULATOR (MODUPLUS®)
APPLICATION
The V7335A ”5000” series electric modulating regulator
(Moduplus®), when installed on VK41../VK81.. series gas
controls, expands their application versatility and provides
the following extra functions:
Servo pressure regulation
Outlet pressure is held at a constant value regardless of
fluctuations of input pressure.
Modulating control
Between minimum and maximum outlet pressure gas
supply to the appliance is dependent on the electrical
signal to modulating coil.
Mechanical limitation of outlet pressure
The minimum and maximum burner pressures are
mechanically adjusted to guarantee good burner
performance in case the modulating control should
become out of range.
The Moduplus® is designed to work together with the W4115
logic control, T7335A thermistor temperature sensor and an
advanced range of micro computer based modulating
controls.
SPECIFICATIONS
In general the specifications of the VK41../VK81.. gas
controls are valid. See instruction sheet EN1R-9162
However the following information is deviating and replaces
therefore the relevant information of that instruction sheet.
Model
Gas controls:
Suffix M: fast opening with electric modulating regulator.
Suffix N: slow opening with electric modulating regulator.
Electric modulating regulator:
V7335A low voltage (Moduplus®)
Adjustment points and dimensions
See fig. 1 page 3
Regulator outlet pressure range
See table 1. page 1
Electrical rating
See table 2 page 2
Electrical connection
The Moduplus® is provided with quick connect 2.8 x 0.8 mm
terminals which are suitable for appropiate receptacles.
Pressure feedback connection
The Moduplus® has a nipple with 6 mm outer diameter for
connection between regulator and combustion chamber of
appliance.
Maximum operating pressure
The P
max.
indication on the housing of the gas control is the
maximum pressure at which the gas control functions safely.
However the maximum operating pressure is limited by the
pressure range of the Moduplus® concerned.
60 mbar for pressure range 1 ... 25mbar / 1 ... 37 mbar
Table 1. Outlet pressure range
Pressure
range (mbar)
Setting outlet pressure range (mbar)
Minimum Maximum
1 ... 25 1 ... 12 (min setting + 5) ... 25
1 ... 37 1 ... 25 (min setting + 5) ... 37
Question and Answer IconNeed help?

Do you have a question about the Honeywell 5000 Series and is the answer not in the manual?

Honeywell 5000 Series Specifications

General IconGeneral
Series5000
Enclosure RatingIP20
Output TypeRelay
Communication ProtocolModbus
Operating Temperature0°C to 50°C

Summary

Application of Moduplus

Servo Pressure Regulation

Outlet pressure is held at a constant value regardless of fluctuations of input pressure.

Modulating Control

Outlet pressure is dependent on the electrical signal to the modulating coil.

Mechanical Limitation of Outlet Pressure

Minimum and maximum burner pressures are mechanically adjusted for good burner performance.

Moduplus Specifications

Model and Regulator Type

Specifies gas controls suffix M (fast) and N (slow) opening, and V7335A low voltage regulator.

Outlet Pressure Range

Details the available outlet pressure ranges as specified in Table 1.

Electrical Rating

Details the electrical rating of the coils as specified in Table 2.

Maximum Operating Pressure

States the maximum operating pressure is limited by the Moduplus® pressure range.

Adjustment, Checkout, and Maintenance

Adjusting Maximum Pressure Setting

Procedures for setting the maximum outlet pressure using Method 1 or Method 2.

Adjusting Minimum Pressure Setting

Procedures for setting the minimum outlet pressure.

Adjusting Intermediate Pressure Setting

How to set intermediate pressure for modulating or fixed modes.

Checkout Procedure

Steps to observe appliance function through a complete cycle after adjustments.

Maintenance Recommendations

Yearly check of minimum and maximum settings and necessary readjustment.

Moduplus Tradeline Mounting

Mounting on Gas Valve

Step-by-step guide for mounting the Moduplus® Tradeline on a gas valve.

Related product manuals