Installation and Operations Guide
|
Initial firmware and operator workstation setup
© Honeywell. All Rights Reserved. LT-VLXEXPAXMIOG Rev. 01
41
To connect to the VLX/VLX-Platinum and start a HyperTerminal session
1. Connect the computer to the VLX/VLX-Platinum with an AC-2650
cable. Attach one end to the computer’s 9-pin serial port (note the COM
port), the other to the AC-2650 jack on the VLX/VLX-Platinum.
2. Start HyperTerminal, which is typically under Programs/Accessories on
the Windows Start Menu.
HyperTerminal prompts you to start a connection profile in the
Connection Description dialog box.
3. Type a name for the new connection, select a different icon if desired,
and then click OK.
4. In the Connect To dialog box, from the Connect Using list, select the
COM port to which the AC-2650 cable is connected and then click OK.
To Next Page
Loading...
