CT47 Mobile Computer Series User Guide 5
Battery Part Numbers
CT47 Models
Charge the Battery Before Use
The mobile computer ships with a partially charged battery. Charge the battery
with a CT40/CT45 series charging device for a minimum of 3 hours.
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
About the USB Type C Connector
You can use a USB cable to charge the mobile computer from a host device (e.g.,
laptop or desktop computer). The connected host device must supply a minimum
power output of 5V, 0.5A to the mobile computer.
Note: If the mobile computer is drawing more current than supplied by the charging source,
charging will not take place.
Battery Replacement
If your battery power is low, you need to either charge the battery in the computer
or replace it with a charged battery.
Before Attempting to Remove the Battery
Always do one of the following before removing the battery:
• Power Off the computer.
• Place the unit in Swap Battery mode (see below).
CT47 Swap Battery Mode
Swap Battery mode places the computer in a lower power state so that the battery
can be removed for a short time.
Model Configuration
x = configuration variations
Battery P/N
CT47-xxx-xxxxxxx 318-055-021
Configuration number (CN) is located on the label in the battery well of the mobile computer.
Caution: Read Battery Recommendations and Safety Precautions on page 11
and all cautionary markings on the battery, charging peripheral, and
device using the battery before attempting to install, use, or charge
the battery.
To Next Page
Loading...
Need help?
General
